Pedrollo RXV Vortex Stainless Steel Submersible Pumps

PERFORMANCE RANGE

Flow rate up to 450 L/min (27 m³/hr)
Dynamic head up to 14.5m

OPERATING LIMITS

Maximum operating depth 10m below water level
Fluid maximum temperature 50°C
(+ 90 °C for a maximum period of 3 minutes)
Maximum passage for suspended solids Ø 20mm for RXV 2
Maximum passage for suspended solids Ø 40mm for RXV 3-4-5
Maximum emptying level 25mm from the bottom for RXV 2
Maximum emptying level 40mm from the bottom for RXV 3-4-5

Innovative design and advanced technology are incorporated into these new pumps, designed to be easy to use and extremely reliable.

PUMP INSTALLATION AND APPLICATIONS

RXV pumps are suitable for lifting dirty water containing suspended solid bodies. They have been designed for easy use and are extremely reliable even when subjected to continuous use (subject to correct installation). The motor is fully cooled and has an ample reserve of power plus a double seal system with barrier chamber of bio-degradable oil. The motor and the pump are easily removed, making maintenance and repair simple.

These pumps are particularly suitable for draining flooded areas (basements, garages etc.) emptying swimming pools, tanks and aquariums, waste household water disposal (dishwashers, washing machines), supplying garden fountains, small scale irrigation for gardens in general from collection tanks and emptying sump pits.

PERFORMANCE

When designing performance levels for RX pumps, special attention was given to typical requirements for domestic usage.

- performance curves specially designed for high delivery rates at the low installed power rating
Curve tolerance according to EN ISO 9906 APP A.

STRUCTURAL CHARACTERISTICS

- DELIVERY BODY made from AISI 304 stainless steel, fitted with UNI ISO 228/1 1½ inch or 1¼ inch gas
threaded vertical delivery port.
- SUCTION STRAINER made from AISI 304 stainless steel, providing the support base for the pump
AISI 304 stainless steel IMPELLER
EXTERNAL FLOAT SWITCH for automatic pump operation.
AISI 304 stainless steel MOTOR SUPPORT
EN 10088-3-1.4104 stainless steel MOTOR SHAFT
DOUBLE SEAL SYSTEM carbon / ceramic (or optional silicon carbide hard faced) mechanical seal on the pump side, and lip seal on the motor side. A barrier oil chamber of biodegradable oil lubricates and cools the sealing surfaces in the absence of water.
Sealed induction MOTOR suitable for continuous duty with built-in thermal cutout device (motor protector). INSULATION class F (provides the motor with a considerable overload tolerance and substantially increases the service life of the motor itself). The motor is cooled by the pumped liquid.
PROTECTION IP 68.
UK pumps supplied with 10 metres of cable. Other alternatives on request.
CONSTRUCTION AND SAFETY STANDARDS in compliance with EN 60 335-1 (IEC 335-1, CEI 61-150)
EN 60034-1 (IEC 34-1, CEI 2-3).